Order Of Installing Trunk Blades; Installing Gcd-Cot( ), Gcd-4Diopb, Gcd-4Odtb Or; Gcd-2Bria Blades; Table 4-2 Adding Daughter Board To Chassis Example - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual

Table 4-2 Adding Daughter Board to Chassis Example

Blade
Blade
Slot #
1 GCD-16DLCA
2 GCD-8DLCA
(no daughter
board)
3 GCD-16DLCA
— —
The system automatically recognizes each blade installed in the system. If a
blade was installed previously in a slot and another type of blade is to be
installed in that same slot, the blade must first be removed from the chassis
and then the slot definition removed using Program 90-05 or deleted
through WebPro Blade Configuration prior to installing the new blade.
This same condition applies to extensions and other devices connected to
the system. For example, if a port was used previously for a telephone and
a DSS Console is to be installed in that same port, the telephone must be
undefined in Program 10-03 before the console is connected.
2.2.3

Order of Installing Trunk Blades

2.2.3.1

Installing GCD-COT( ), GCD-4DIOPB, GCD-4ODTB or

GCD-2BRIA Blades

The order in which trunk blades are physically inserted
determines the numbering plan.
Extension Blade
Numbers Slot #
101~116 1
117~124 2
125~140 3
4
—
To avoid unexpected extension/trunk numbering if
the VoIP or Voice Mail daughter board registers
with the system first, install these boards after the
CAUTION
other extension and trunk blades are installed.
Extension
Blade
Numbers
GCD-16DLCA 101~116
— —
GCD-16DLCA 125~140
GCD-8DLCA 141~156
(with daughter
board)
4-7