2- Install The Analogue Trunk Card; Mounting The 3Coidb Daughter Card; 308 Trunk + Extension Card - NEC SL2100 Quick Install Manual

Install the 3COIDB Card

2- Install the Analogue Trunk Card

The SL2100 chassis does not have any trunk ports pre-installed, you install the trunk card of your choice.
! Ensure the SL2100 is powered off before removing/installing any card.

Mounting the 3COIDB Daughter card

The IP7WW-3COIDB-C1 card is a daughter card that must be installed onto any of the following interface cards:
IP7WW-000U-C1
IP7WW-082U-B1
IP7WW-008U-C1
Each interface card can have one daughter card installed.
Remove the plastic knockout from the front panel of the interface card. The COI interface blade only requires
one of the two knockouts to be removed. Check alignment of the knockouts with the daughter card.
The IP7WW-3COIDB-C1 card is supplied with two Nylon pillars already installed and a securing screw and metal
spacer.
Align the 3COIDB board Nylon spacers and connector with the SL2100 interface card and push in firmly.
Secure the 3COIDB with the screw through to the metal spacer.

308 Trunk + Extension card

The IP7WW-308U-A1 card is an extension interface card with 3 analogue trunks included, this card does not
require any daughter card mounting and can be installed into any of the universal slots – Note that slot 4 does
not support digital extensions.
Quick Install Guide – SL2100 with Analogue Trunks rev 1.1
Trunk carrier card
8 Digital Extension (2wire) and 2 SLT extension card
8 Analogue extension card
9