9B-18 Lighting Systems:
Reference waveform No.1
Vehicle speed signal (1).
Vehicle speed signal is pulse. Pulse frequency varies
depending on vehicle speed.
Measurement terminal
Oscilloscope setting
Measurement condition
Headlight Housing Removal and Installation
WARNING
!
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb, to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
• Be sure to read "Precautions for Discharge
Headlight Service (If Equipped)" before
starting to service work.
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper. Refer to "Front Bumper and
Rear Bumper Components in Section 9K".
3) Remove headlight mounting bolts.
4) Detach headlight housing (1) from vehicle.
5) Disconnect couplers (2) from headlight housing (1).
1
CH 1: "G14-16" to "G14-9"
CH 1: 2 V
TIME: 20 ms/DIV
Engine is running and
vehicle speed 40 km/h (24
mph)
Repair Instructions
S7RW0A9206001
2
I5RW0A920004-01
Installation
Reverse removal procedure noting the following.
• Install headlight mounting bolts and clip (1), and then
tighten headlight mounting bolts ("1" – "2") according
to numerical order as shown in figure.
"1"
• After installation, be sure to inspect and adjust aiming
referring to "Headlight Aiming Adjustment with
Screen".
I6RW0C920013-02
1
"2"
I5RW0A920005-01
Need help?
Do you have a question about the SX4 and is the answer not in the manual?
Questions and answers