Steering Column Inspection; Ignition Switch Cylinder Assembly Removal And Installation (Non- Keyless Start Model) - Suzuki 2006 SX4 Service Manual

3) Align flat part "a" of steering lower shaft (1) with bolt
hole "b" of shaft joint (2) of column as shown. Then
insert lower shaft into shaft joint of steering column.
4) Tighten lower shaft upper joint bolt (3) to specified
torque.
CAUTION
!
After tightening column nuts, tighten steering
shaft upper joint bolt. Otherwise, shaft joint
bearing is damaged.
Tightening torque
Steering lower shaft assembly upper joint bolt
(a): 25 N·m (2.5 kgf-m, 18.5 lb-ft)
2
"b"
"a"
1
5) Install lighting switch and wiper switch to steering
column.
6) (Immobilizer model)
Install immobilizer control module from steering
column, referring to "ICM Removal and Installation in
Section 10C".
7) Install contact coil cable assembly and steering
wheel referring to "Contact Coil Cable Assembly
Removal and Installation" and "Steering Wheel
Removal and Installation".
8) Connect negative (–) cable to battery.
9) Enable air bag system referring to "Enabling Air Bag
System in Section 8B".

Steering Column Inspection

Check steering column for damage and operation
referring to "Checking Steering Column for Accident
Damage".
Ignition Switch Cylinder Assembly Removal
and Installation (Non- Keyless Start Model)
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
3) Remove steering column upper and lower covers.
4) (Immobilizer model)
Remove immobilizer control module referring to
"ICM Removal and Installation in Section 10C".
5) Remove ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) Insert 2 mm (0.078 in.) rod (2) through hole (3)
c) Detach ignition switch cylinder assembly (1) from
3, (a)
I5RW0A620007-01
Installation
1) Install ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) In this state, push ignition switch cylinder
2) (Immobilizer model)
Install immobilizer control module referring to "ICM
Removal and Installation in Section 10C".
3) Install upper and lower cover and screws.
4) Connect negative (–) cable to battery.
5) Enabling air bag system referring to "Enabling Air
Bag System in Section 8B".
S6RW0C6206009
6) (Immobilizer model)
If ignition switch cylinder assembly (that is ignition
key) has replaced, register ignition key transponder
code to ECM referring to "Registration of the Ignition
Key in Section 10C".
Steering Wheel and Column:
and push ignition switch cylinder lock.
steering lock assembly (4).
4
assembly into steering lock assembly till it clicks.
6B-8
S6RW0C6206010
2
3
1
I5JB0A620025-01