Height Sensor Removal And Installation (If Equipped) - Suzuki SX4 Service Manual

9B-30 Lighting Systems:
Height Sensor Removal and Installation (If
Equipped)
Removal
CAUTION
!
• Do not remove bracket (4) and link (3) from
height sensor (2). Removal will spoil its
original function. If faulty condition is
found, replace it with new one in a set.
• If height sensor was dropped from a height
of 30 cm (0.9 ft) or more, replace it with
new one.
1) Disconnect negative (–) cable at battery.
2) Disconnect height sensor connector (1) from height
sensor (2).
3) Remove front and rear height sensor (2) with its
bracket (4) from suspension frame (6) or rear floor
center cross member (7) and lower arm (5).
[A]
2
3
5
[B]
1 2
3
4
[A]: Front [B]: Rear
S7RW0A9206022
1
4
6
4
4
7
5
I6RW0C920022-01
Installation
For installation, reverse removal procedure noting the
following.
• Check that bracket and link of height sensor are not
deformed.
• Tighten height sensor bolts and nuts to specified
torque.
Tightening torque
Height sensor bolt (a): 5.5 N·m (0.6 kgf-m, 4.0 lb-ft)
Height sensor nut (b): 13 N·m (1.3 kgf-m, 9.5 lb-ft)
[A]
[B]
[A]: Front
• Connect connector securely.
• After installation, initialize headlight auto leveling
system referring to "Initialization of Headlight Auto
Leveling System".
(a)
(b)
(a)
(a)
I6RW0C920023-01
[B]: Rear