Steering Column Assembly Inspection; Ignition Switch Cylinder Assembly Removal And Installation (Without Keyless Start System) - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:

Manual (35 pages)

Table of Contents

6B-10 Steering Wheel and Column:

4) Install column support bracket. (if equipped)

5) Install new steering upper shaft upper joint bolt (2)

and nut (1). Tighten new steering upper shaft upper

joint nut (1) to specified torque.

Do not reuse steering upper shaft upper joint

bolt and nut.

Be sure to use new bolt and nut when

Tightening torque

Steering upper shaft assembly upper joint nut:

23 N·m (2.3 kgf-m, 17.0 lb-ft)

6) For A/T vehicle, connect shift (key) interlock cable

(1) to ignition switch with ignition switch turned at

ACC position.

And then turn ignition switch LOCK position.

I5JB0A620024-01

I5JB0A620019-01

7) Connect steering lock assembly connector.

8) Install washer switch referring to "Windshield Wiper

and Washer Switch Removal and Installation in

Section 9D".

9) Install lighting switch referring to "Headlight Switch

(in Lighting Switch) Removal and Installation in

Section 9B".

10) (Immobilizer model)

Install immobilizer control module (ICM) referring to

"Immobilizer Control Module (ICM) Removal and

Installation: For Petrol Engine Model in Section 10C"

or "Immobilizer Control Module (ICM) Removal and

Installation: For Diesel Engine Model in Section

11) Install instrument panel under cover (1) to instrument

12) Install steering wheel and contact coil cable

assembly by referring to "Steering Wheel Removal

and Installation" and "Contact Coil Cable Assembly

Removal and Installation".

13) Connect negative (–) cable to battery.

14) After installing steering column assembly, be sure to

enable air bag system by referring to "Enabling Air

Bag System in Section 8B".