License Light Removal And Installation (Sedan); Front Fog Light Assembly Removal And Installation (If Equipped) - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (278 pages)
Table of Contents
Advertisement
9B-26 Lighting Systems:
License Light Removal and Installation (Sedan)
Removal
1) Remove trunk lid trim (1) from trunk lid panel.
2) Remove trunk lid license garnish referring to "Trunk
Lid Lock Assembly Components (Sedan Model) in
Section 9F"
3) Disconnect coupler from license light socket.
4) Remove license light bulb (1) as shown.
5) Push locking part (2) to arrow direction, and then
remove license light lens.
2
1
Installation
Reverse removal procedure for installation.
S7RW0A9206029
1
I6RW0B920004-01
1
2
I6RW0B920005-01
Front Fog Light Assembly Removal and
Installation (If Equipped)
WARNING
!
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper. Refer to "Front Bumper and
Rear Bumper Components in Section 9K".
3) Disconnect coupler from fog light (1).
4) Remove front fog light as follows.
Hatchback
• Detach fog light pushing clips to arrow direction,
and remove front fog light.
Sedan
• Remove fog light screws (2), and remove front fog
light.
2
Installation
Reverse removal procedure for installation nothing the
following:
• After installing, adjust aiming referring to "Front Fog
Light Aiming Adjustment with Screen (If Equipped)".
S7RW0A9206016
1
I5RW0A920013-01
2
1
I7RW0A920002-02
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SX4 and is the answer not in the manual?
Questions and answers
Adjust throttle motor
The idle speed on a Suzuki SX4 should be controlled by the Idle Air Control Valve (IACV) rather than adjusting the idle screw on the throttle body, as the screw is factory set. Before using compressed air in the idle-air-bypass passages, the IACV should be removed to prevent damage to its delicate mechanism. If there is an issue with idle speed, checking the IACV function and referring to the SX4 service manual is recommended.
This answer is automatically generated
I have an issue of crank but not starting When I scan it brought this codeU0100 Which means no communication thou crank sensor wire was cut off but it was fix back What could be wrong and what could be the solution,
increasing revs when changing gears
The Suzuki SX4 may have increasing revs when changing gears due to its drive-by-wire system and the difference in final drive ratios between the manual (4.41) and automatic (2.81) transmissions. This difference causes high cruising RPMs in the manual version and sluggishness in the automatic. Additionally, if the revs climb while going uphill, it may be due to the transmission downshifting or kicking out of overdrive. Other possible causes include low transmission fluid, abuse, or a faulty transmission design.
This answer is automatically generated