Turn Signal And Hazard Warning Relay Inspection; License Light Assembly Removal And Installation (Hatchback) - Suzuki SX4 Service Manual

Turn Signal and Hazard Warning Relay
Inspection
1) Connect turn signal and hazard warning relay (1),
battery (2) and six test bulbs ((12 V, 21 W) (3) and 12
V, 5 W (4)) as shown.
3 3
2) Check turn L circuit
Connect terminal "5" and battery negative (–)
terminal by a jumper wire.
Check left side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
3) Check turn R circuit
Connect terminal "6" and battery negative (–)
terminal by a jumper wire.
Check right side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
S7RW0A9206014
1
3 2 1
8 7 6 5 4
4
2
I4RS0A920014-01
3 2 1
8 7 6 5 4
I4RS0A920015-01
3 2 1
8 7 6 5 4
I4RS0A920016-01
4) Check Hazard ON circuit
Connect terminal "8" and battery negative (–)
terminal by a jumper wire.
Check all bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1 1
License Light Assembly Removal and
Installation (Hatchback)
Removal
1) Disconnect negative (–) cable at battery.
2) Remove rear end door license garnish referring to
"Rear End Door Lock Assembly Components
(Hatchback Model) in Section 9F".
3) Disconnect coupler (1) from license light.
4) Push locking part to arrow direction, and then
remove license light.
2
4
5
3
2. License light socket
3. License light lens
4. License light bulb
5. License light socket cover
Installation
Reverse removal procedure for installation.
Lighting Systems: 9B-25
3 2 1
8 7 6 5 4
I4RS0A920017-01
S7RW0A9206015
1
2
I5RW0A920012-01