Source (Port Monitoring) - Dell C9000 Series Reference Manual
Networking command-line reference guide
Hide thumbs
Also See for C9000 Series:
- Configuration manual (9 pages) ,
- Networking configuration manual (1251 pages)
Table of Contents
Advertisement
source (port monitoring)
Configure a port monitor source.
C9000 Series
Syntax
source interface | range destination interface direction {rx | tx
| both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source interface
range
destination
Enter the one of the following keywords and slot/port
information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keyword port-
channel and a port-channel ID.
•
For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigE then the pe-id / stack-unit / port-id
information.
•
For a VLAN interface, enter the keyword VLAN and a vlan-id
number. Range is from 1 to 4094.
•
For a remote VLAN interface, enter the keyword Remote-
VLAN and a vlan-id number. Range is from 1 to 4094
•
For a port channel interface, enter the keyword port-
channel and a port-channel ID.
NOTE:
You cannot configure VLAN 4092 and 4093.
These VLANs are reserved for internal use.
Enter the keyword range to specify the list of interfaces.
Enter the keyword destination to specify the destination
interface.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keyword port-
channel and a the port-channel ID.
Port Monitoring
1770
Advertisement
Chapters
Table of Contents
