Show Ip Ospf Interface - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS

SHOW IP OSPF INTERFACE

show ip ospf interface
Overview Use this command to display interface information for OSPF.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and
Syntax show ip ospf interface [<interface-list>]
Mode User Exec and Privileged Exec
awplus#
Examples
Output Figure 28-17: Example output from the show ip ospf interface command
awplus#show ip ospf interface
vlan2 is up, line protocol is up
Internet Address 1.1.1.1/24, Area 0.0.0.0, MTU 1500
Process ID 0, Router ID 33.33.33.33, Network Type BROADCAST, Cost: 10
Transmit Delay is 1 sec, State Waiting, Priority 1, TE Metric 0
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Neighbor Count is 0, Adjacent neighbor count is 0
Crypt Sequence Number is 1106347721
Hello received 0 sent 1, DD received 0 sent 0
LS-Req received 0 sent 0, LS-Upd received 0 sent 0
LS-Ack received 0 sent 0, Discarded 0
C613-50631-01 Rev A
Parameter
<interface-list>
show ip ospf interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Configuration_Guide.
Description
The interfaces to display information about. An interface-list
can be:
• a VLAN (e.g. vlan2)
• the loopback interface (lo)
• a continuous range of interfaces separated by a hyphen
(e.g. vlan10-20)
• a comma-separated list (e.g. vlan1,vlan10-20). Do not mix
interface types in a list.
"Getting_Started
1194