View
Layer-2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the link-aggregation mode dynamic command to configure an aggregation group to work in
dynamic aggregation mode.
Use the undo link-aggregation mode command to restore the default.
By default, an aggregation group works in static aggregation mode.
If there is any member port in an aggregation group, you cannot modify the aggregation mode of the
aggregation group.
Examples
# Configure the aggregation group of Bridge-aggregation 1 to work in dynamic aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
port link-aggregation group
Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet interface view
Default Level
2: System level
Parameters
number: Aggregate group number. The value range is 1 to 1,024.
Description
Use the port link-aggregation group command to assign the current Ethernet interface to the
specified aggregation group.
Use the port link-aggregation group command to remove the current Ethernet interface from the
specified aggregation group.
Note that:
If the Ethernet interface is a Layer-2 interface, you must assign it to a Layer-2 aggregation group.
1-11