Dldp Interval - 3Com S7906E Command Reference Manual

Parameters
None
Description
Use the dldp enable command to enable DLDP.
Use the undo dldp enable command to disable DLDP.
When executed in system view, these two commands enables/disables DLDP globally; when executed
in Ethernet port view, these two commands enables/disables DLDP on the current port; when executed
in port group view, these two commands enables/disables DLDP on all the ports in the port group.
By default, DLDP is disabled globally or on a port.
These two commands are applicable to Layer 2 Ethernet ports, including optical ports and
electrical ports.
DLDP can take effect only when it is enabled both globally and on a port.
Examples
# Enable DLDP globally.
<Sysname> system-view
[Sysname] dldp enable
# Enable DLDP on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dldp enable
# Enable DLDP for all the ports in port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member GigabitEthernet 2/0/1 to GigabitEthernet 2/0/3
[Sysname-port-group-manual-1] dldp enable

dldp interval

Syntax
dldp interval time
undo dldp interval
View
System view
Default Level
2: System level
1-6