Display Smart-Link Group - 3Com S7906E Command Reference Manual

display smart-link group

Syntax
display smart-link group { group-id | all }
View
Any view
Default Level
1: Monitor level
Parameters
group-id: Smart link group ID. The minimum value is 1, while the maximum value is 48.
all: Displays information about all smart link groups.
Description
Use the display smart-link group command to display information about the specified or all smart link
groups.
Examples
# Display information about smart link group 1.
<Sysname> display smart-link group 1
Smart link group 1 information:
Device ID: 000f-e200-8500
Preemption mode: ROLE
Preemption delay: 1(s)
Control VLAN: 1
Protected VLAN: Reference Instance 0 to 2, 4
Member
-------------------------------------------------------------------------------
GigabitEthernet2/0/1
GigabitEthernet2/0/2
Table 1-2 display smart-link group command output description
Smart link group 1 information
Device ID
Preemption mode
Control-VLAN
Protected VLAN
Member
Role
Role State
MASTER ACTVIE
SLAVE STANDBY
Field
Flush-count Last-flush-time
1 16:37:20 2008/04/21
2 17:45:20 2008/04/21
Information about smart link group 1
Device ID
Preemption mode, which can be role for preemption
enabled or none for preemption disabled.
Control VLAN ID
Protected VLANs of the smart link group. Referenced
MSTIs are displayed here. To view the VLANs mapped to
the referenced MSTIs, use the display stp
region-configuration command.
Member of the smart link group
Port role: master or slave
1-2
Description