State
Flush-count
Last-flush-time
flush enable
Syntax
flush enable [ control-vlan vlan-id ]
undo flush enable
View
Smart link group view
Default Level
2: System level
Parameters
control-vlan vlan-id: Specifies the control VLAN used for transmitting flush messages. The vlan-id
argument ranges from 1 to 4094. If no VLAN is specified, VLAN 1 applies by default.
Description
Use the flush enable command to enable flush update.
Use the undo flush enable command to disable flush update.
By default, flush update is enabled for smart link groups and VLAN 1 is used for flush message
transmission.
Different smart link groups must be configured with different control VLANs.
Related commands: smart-link flush enable.
Examples
# Enable flush update for smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] flush enable
port
Syntax
port interface-type interface-number { master | slave }
undo port interface-type interface-number
View
Smart link group view
Field
Description
Port state: active or standby
Number of transmitted flush messages
Time when the last flush message was transmitted (NA
indicates that no flush message has been transmitted)
1-3
Need help?
Do you have a question about the S7906E and is the answer not in the manual?