Honda Accord 2008 Manual page 675

07/11/02 09:17:58 61TA0000_110_0356
Fuel Supply System
Fuel Pump Circuit Troubleshooting (cont'd)
26. Turn the ignition switch to ON (II), and measure
voltage between driver's under-dash fuse/relay box
connector F (33P) terminal No. 22 and body ground
after 2 seconds.
＊１２
Is there battery voltage?
YES
NO −
fuse/relay box (see page 22-84), then go to step 27.
27. Turn the ignition switch to LOCK (0).
28. Remove the rear seat cushion (see page 20-224).
29. Remove the access panel from the floor (see page
11-373).
11-356
DRIVER'S UNDER-DASH FUSE/RELAY BOX
CONNECTOR F (33P)
IMOFPR (GRY)
Wire side of female terminals
−
Go to step 27.
If needed, replace the driver's under-dash
30. Turn the ignition switch to ON (II), and measure
voltage between fuel tank unit 4P connector
terminal No. 2 and body ground within 2 seconds.
FUEL TANK UNIT 4P CONNECTOR
Wire side of female terminals
Is there battery voltage?
−
YES Go to step 35.
NO − Go to step 31.
31. Turn the ignition switch to LOCK (0).
32. Remove PGM-FI main relay 2 (FUEL PUMP).
FUEL PUMP (PNK)
＊１３