Honda Accord 2008 Manual page 673

07/11/02 09:17:57 61TA0000_110_0354
Fuel Supply System
Fuel Pump Circuit Troubleshooting (cont'd)
13. Measure voltage between PGM-FI main relay 2
(FUEL PUMP) 4P connector terminal No. 2 and
body ground.
＊０６
PGM-FI MAIN RELAY 2 (FUEL PUMP) 4P CONNECTOR
Is there battery voltage?
YES
NO −
• Check the No. 9 FUEL PUMP (20 A) fuse in the
driver's under-dash fuse/relay box.
• If the fuse is OK, replace the driver's under-dash
fuse/relay box (see page 22-84).
14. Turn the ignition switch to LOCK (0).
11-354
IG1
Terminal side of female terminals
−
Go to step 14.
15. Connect PGM-FI main relay 2 (FUEL PUMP) 4P
connector terminal No. 3 to body ground with a
jumper wire.
PGM-FI MAIN RELAY 2 (FUEL PUMP) 4P CONNECTOR
IMOFPR
JUMPER WIRE
Terminal side of female terminals
16. Jump the SCS line with the HDS.
17. Disconnect ECM/PCM connector A (49P).
18. Check for continuity between body ground and
ECM/PCM connector terminal A16.
ECM/PCM CONNECTOR A (49P)
IMOFPR (GRY)
Terminal side of female terminals
Is there continuity?
YES − Go to step 19.
−
NO Repair open in the wire between PGM-FI main
relay 2 (FUEL PUMP) and the ECM/PCM (A16).
19. Reinstall PGM-FI main relay 2 (FUEL PUMP).
＊０７
＊０８