Priming Pump; Conditions For Using Priming Pump; Fuel Filter And Water Separator - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DI07-4

Priming Pump

The priming pump installed in fuel pump is the device to fill the fuel into the fuel filter. When the vehicle is under the
conditions as below, press the priming pump until it becomes rigid before starting the engine.
WARNING
Never reverse filter or use it in other place (clean side)

Conditions for using Priming Pump

1. After run out of fuel
2. After draining the water from fuel separator
3. After replacing filter or any intervention on system

Fuel Filter and Water Separator

1. Fuel filter
3. Priming pump
Notice
• When replaced the fuel filter or drained the water from fuel filter, press the priming pump until it becomes
rigid before starting the engine.
• The water drain from fuel filter should be performed whenever changing the engine oil.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
2. Water drain plug
(to be drained every 15,000km max.)
Draining could be done at same time than oil
change
Y220_07003
FUEL SYSTEM
DI ENG SM - 2004.4