Canon imageRUNNER ADVANCE 6075 Series Service Manual page 703

E Detail
Location Item
Code Code
E240 -0001 -05 Title 3 minutes passed with pickup request waiting status
Remedy 1. Check the connection of the Connector.
2. Check the connection of the Sub PCB in the Main
Controller PCB 1 Box.
3. Check the connections of the DC Controller PCB and the
Main Controller PCB 1. Replace the PCB(s) if necessary.
Description It was detected that 3 minutes passed with pickup request
waiting status.
E240 -0002 -05 Title 3 minutes passed with image output request waiting status
Remedy 1. Check the connection of the Connector.
2. Check the connection of the Sub PCB in the Main
Controller PCB 1 Box.
3. Check the connections of the DC Controller PCB and the
Main Controller PCB 1. Replace the PCB(s) if necessary.
Description It was detected that 3 minutes passed with image output
request waiting status.
E240 -0003 -05 Title Software sequence error after the jam
Remedy 1. Check the connection of the Connector.
2. Check the connection of the Sub PCB in the Main
Controller PCB 1 Box.
3. Check the connections of the DC Controller PCB and the
Main Controller PCB 1. Replace the PCB(s) if necessary.
Description A software sequence error (engine bug) was detected after
the jam.
E246 -0001 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E246 -0002 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E246 -0003 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E246 -0005 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E247 -0001 -00 Title System error
Remedy Contact to the sales companies.
Description ---
7
Error Code > Error Code > Error Code Details > E202 to E280
Description
7 Error Code > Error Code > Error Code Details > E202 to E280
E Detail
Location Item
Code Code
E247 -0002 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E247 -0003 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E247 -0004 -00 Title System error
Remedy Contact to the sales companies.
Description ---
E248 -0000 -00 Title SRAM error
Remedy Main Controller PCB 2.
Description SRAM check error when the power is turned ON.
E248 -0001 -04 Title EEPROM error
Remedy Failure of the Reader Controller PCB (PCB1).
Description An error when EEPROM power for the Reader Controller
PCB (PCB1) is turned ON.
E248 -0002 -04 Title EEPROM error
Remedy Failure of the Reader Controller PCB (PCB1).
Description EEPROM writing error for the Reader Controller PCB (PCB1).
E248 -0003 -04 Title EEPROM error
Remedy Failure of the Reader Controller PCB (PCB1).
Description Reading error after writing to EEPROM for the Reader
Controller PCB (PCB1).
E263 -0000 -05 Title Error in Current Sensor reference voltage generation
Remedy 1. Check the connection between the AC Driver PCB and the
Main Driver PCB (connector disconnection, open circuit,
short circuit of harness).
AC Driver side: J615, Main Driver side: J103
2. Replace the AC Driver PCB.
3. Replace the Main Driver PCB (PCB2).
Description When CP54 on the Main Driver PCB was measured with a
tester, the reference voltage (normally 2.5 V) was not within
the range of reference value (2.2 to 2.7 V).
7-18
Description
7-18