Removing The Pre-Transfer Charging Wire Cleaner, Cleaner Holder - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Wire Cleaner, Cleaner Holder
CAUTION:Points to Caution at Installation
Be sure to fit the Transfer Charging Assembly to the groove on the host machine and
install it horizontally.
<Processing when replacing the parts>
1) Clear the parts counter. (COPIER>COUNTER>DRBL-1>PO-UNIT)
2) Clean the Charging Wire. (COPIER>FUNCTION>CLEANING>WIRE-EX)
4 Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Wire Cleaner, Cleaner Holder
Removing the Pre-transfer Charging Wire Cleaner,
Cleaner Holder
<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Pre-transfer Charging Assembly. (Refer to page 4-108)
<Procedure>
1) Displace the Shield Plate Retainer Block to open the Shield Plate in the direction of the
arrow.
• 1 Screw (to loosen)
F-4-120
4-109
Loosen
F-4-121
4-109