Canon imageRUNNER ADVANCE 6075 Series Service Manual page 413

4
Parts Replacement and Clearning > Main Controller > Removing Main Controller PCB 2
6) Install the Main Controller PCB 1 Unit.
• 3 Connectors
x3
7) Install the Main Controller Right Cover Unit.
• 1 Screw
4 Parts Replacement and Clearning > Main Controller > Removing Main Controller PCB 2
8) Fully tighten the loosened screws to secure the Main Controller PCB 2, Channel Link PCB,
and DC Controller PCB in that order. Check that the connectors of the PCBs are properly
connected.
9) Install the covers removed in this procedure in reverse order.
• Controller Box Inner Cover
• Rear Cover
• Controller Box (Close it.)
• Left Rear Inner Cover
• Connector Cover
• Remove the Left Rear Cover.
3. Specify and register the data again of the Main Controller PCB 2.
F-4-72
1) After the parts are assembled, turn ON the power.
2) Restore the backup data.
Restoring the backup data by SST.
When there is HDD Encryption Board:
Use remote UI.
Management Settings > Data Management > Import/Export
3) Specify and register the data again.
See the list of Settings/Registration data that was printed before replacement, and then
specify and register the data once again.
4) When an encryption key/certificate/CA certificate has been generated or added by the user,
ask the user to execute reinstallation.
F-4-73
4-92
4-92