Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1067

14) Install the supplied AC input connector in 2 steps ([A] > [B]).
Secure the ground cable
• 1 screw with toothed washer
[B]
9
Installation > Paper Deck Heater Unit-A1 > Installation Procedure (Paper Deck Unit-D1)
[A]
x1
F-9-162
9 Installation > Paper Deck Heater Unit-A1 > Installation Procedure (Paper Deck Unit-D1)
15) Install the relay hareness unit [2] to the rear side panel of the paper deck.
• 2 screws (RS-tight, M4x8) [1]
16) Insert the bind locks of the cable ties in the holes (at [3] shown below) in the rear side
panel to secure the relay harness.
17) Connect the connector at both ends of the relay harness unit to the heater connector [4]
and AC power connector [4] respectively.
x2
x2
18) Reatach the exterior covers of the paper deck in the following sequence;
[1] Top cover (take care not to have the cables caught)
• 4 screws (RS-tight; M4x8)
[2] Front-upper cover (insert the connector)
• 4 screws (RS-tight; M4x8)
[3] Rear cover
• 5 screws (RS-tight; M4x8)
• 2 screws (Binding; M3x8)
[4] Right cover
• 3 screws (RS-tight; M4x8)
9-70
F-9-163
9-70