Installing The Pickup Assembly - Canon imageRUNNER ADVANCE 6075 Series Service Manual

Installing the Pickup Assembly

1) Remove tapes securing tags from the Vertical Path Cover.
2) Open the Vertical Path Cover and remove 2 Pressure Release Spacers at pickup slot for
each cassette.
3) Close the Vertical Path Cover.
4) Open the Front Cover.
5) Press the Release Button to open the Left and Right Decks, and remove the tape.
NOTE:
Be sure to release the Release button slowly because it may not come out if releasing it
abruptly.
9
Installation > Installation > Installing the Pickup Assembly
6) Loosen the screw and slide the Deck Pressure Plate in the direction of the arrow. Check
that the screw position is at the engraved mark [1], and then tighten the screw.
7) Close the Left and Right Decks.
F-9-19
9 Installation > Installation > Installing the Pickup Assembly
9-13
Deck Pressure
Engraved Mark
Plate
Screw
F-9-20
9-13