Downloading System Software (Overwriting) - Canon imageRUNNER ADVANCE 6075 Series Service Manual

■ Downloading System Software (Overwriting)

● [3]: Upgrade (Overwrite all)
Regardless of the system software version in the host machine, all the system software in the
USB memory storage device is downloaded.
Regardless of the system software version in the host machine, all the system software in the
USB memory storage device is downloaded.
Unlike menu [1], this machine is not automatically started despite completion of downloading.
By manually turning OFF/ON the power, the system software is written at the time of startup.
In this case, starting the machine in safe mode deletes the downloaded system software
saved in the temporary storage area; therefore, do not press the numeric keys (2 + 8), but
execute normal startup to execute writing.
Operation procedure
1) Enter download mode.
2) Connect the USB memory storage device to the USB port.
3) Press the key on the Control Panel.
[3] -> [0]: To execute downloading/Any key other than [0] key: To return to the menu screen.
[[[[[ download Menu (USB) ]]]]]]]]]]]
-------------------------------------
[1]: Upgrade (Auto)
[2]: Upgrade (w Confirmation)
[3]: Upgrade (Overwrite all)
[4]: Format HDD
[5]: Backup
[7]: Clear downloaded files
[8]: download Menu 2
[9]: Other Menu
/[3] has been selected. Execute?/
- (OK):0 / (CANCEL):Any other keys -
During downloading, download status is displayed on the Control Panel.
6
Troubleshooting > Version upgrade > Version Upgrade using USB memory Storage Device > Downloading System Software (Overwriting)
F-6-133
6 Troubleshooting > Version upgrade > Version Upgrade using USB memory Storage Device > Downloading System Software (Overwriting)
CAUTION:
In overwriting download mode of the USB memory storage device, all the system
software stored in the USB memory storage device is downloaded as well. Therefore,
be sure to keep the following in mind: If the USB memory storage device includes the
system software of non-connecting option, E753-0001 is displayed when the writing
process is completed.
In the case of an error in downloading of the non-connecting option, the machine can
be recovered by turning OFF/ON the power.
To prevent such error, uncheck the applicable system software so that the system
software of the non-connecting option is not downloaded when downloading the system
software from SST to USB.
Once downloading is complete, a message is displayed to encourage pressing the "Reset"
key.
4) Press the "Reset" key.
Shutdown sequence is executed.
5) Once the message on the touch panel disappears, turn OFF the Main Power Switch.
6) Remove the USB memory storage device.
7) After checking that the LED is turned OFF at the lower right on the Control Panel, turn ON
the Main Power Switch.
Writing to the HDD system area/flash ROM is started after the startup. The screen shows
the countdown once the writing process is properly complete.
When the countdown shows 0, this machine is restarted with the downloaded system
software.
6-68
F-6-134
6-68