Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1115

Installing the System Software Using the SST
The system data stored on the HDD and used to control the host machine will be lost when
the machine is first started up after installing this product. It is important to install the system
software used to control the host machine so that the machine may start up properly after
installation of this product. Details follow.
1. Requirements
1) PC
Service support tool in the version that supports this host machine must be installed.
2) Cross Ethernet Cable
2. Preparing for the Installation of the System Software of Host machine
1) If both PC and the machine are on, turn them off.
2) Connect the PC and the machine using an Ethernet cable.
3) Turn on the PC.
4) Start up the machine in download mode (safe mode).
3. Selecting the System Software
1) Set the CD containing the latest system software in the PC on which the SST is used.
2) Start up the SST.
3) Click 'Register Firmware'.
4) Select the drive in which the System Software CD has been set, and click 'SEARCH'.
5) Click 'REGISTER'.
6) Click OK.
4. Downloading the System Software
1) Click 'CONNECT'.
2) From the list of machine series, select the appropriate model.
3) Select 'Single', and click start.
4) Execute HDD format.
5) After 5 sec from when the power of the host machine is turned OFF, restart the host
machine in download mode of safe mode.
6) When "download mode" is displayed on the control panel, click simple mode start.
7) Click start to execute download.
8) Follow the instruction on the screen and when download is complete, click OK.
9) Exit SST.
10) Check the versions of MN-CONT and LANG etc in service mode (COPIER > Display >
VERSION).
9
Installation > [TYPE-1] Option HDD (250GB) > Execution of Auto Gradation Adjustment
Execution of Auto Gradation Adjustment
When this product is installed, the machine initializes its HDD, resetting the data used for
auto gradation adjustment.
Therefore be sure to execute auto gradation adjustment (full adjust) after installing this kit.
9 Installation > [TYPE-1] Option HDD (250GB) > Execution of Auto Gradation Adjustment
9-118
9-118