Setting After Installation - Canon imageRUNNER ADVANCE 6075 Series Service Manual

22-3) Push the Card Reader External Relay Harness in the Right Rear Cover 1.
NOTE:
When pushing the Card Reader External Relay Harness in the Right Rear Cover 1, be
sure the guide does not interfere when opening/closing the cover.
23) Connect the power plug of the host machine to the power outlet.
24) Open the switch cover and turn ON the main power switch.
9
Installation > Card Reader-C1/Copy Card Reader-F1 > Setting After Installation

Setting After Installation

1) Enter service mode, and set the model of the Card Reader.
• Service Mode > COPIER > OPTION > ACC > CR-TYPE
• In the case of Card Reader-C1, select "1".
• In the case of Copy Card Reader-F1, check that "0" is selected.
NOTE:
The number of card (number of department) can be changed if a request arises from a
user. Make this setting before the step 3).
•
•
•
2) Enter the card number to be used (1 to 2001).
• Service Mode > COPIER > FUNCTION > INSTALL > CARD
F-9-208
NOTE:
1000 cards from the inputted number can be used.
3) To enable the number of sheets, turn OFF/ON the main power switch.
4) Insert the registered card, and check that it is in standby.
NOTE:
After setting, if a request arises from a user and changing the number of card (number
of department), make a following setting. In that case, the current counter information
by department will be reset.
•
•
•
•
9 Installation > Card Reader-C1/Copy Card Reader-F1 > Setting After Installation
Specify the number of cards to be used in service mode (Level 2) > COPIER > OPTION >
FNC-SW > CARD-RNG.
To enable the number of sheets, turn OFF/ON the main power switch.
After that, go through the procedure from step 2).
Execute in service mode > COPIER > FUNCTION > CLEAR > CARD.
Specify the number of cards to be used in service mode (Level 2) > COPIER > OPTION >
FNC-SW > CARD-RNG.
To enable the number of sheets, turn OFF/ON the main power switch.
After that, go through the procedure from step 2).
9-87
9-87