1) Open the DADF and loosen the 2 Fixation Screws securing the Arm Rotation Adjustment
Ring.
2) Remove the 3 Stepped Screws securing the Arm Shaft.
x3
6
Troubleshooting > Other > Adjusting rotation of the Upright Control Panel Arm
F-6-43
6
Troubleshooting > Other > Adjusting rotation of the Upright Control Panel Arm
3) Pull out the Upright Control Panel and the Arm Shaft, and rotate the Arm Rotation
Adjustment Ring to change the phase so that the Fixation Screws do not contact with the
dents formed by tightening the screws.
4) Insert the Upright Control Panel and the Arm Shaft, and retighten the 2 screws loosened in
step 3.
F-6-44
6-25
F-6-45
6-25