Canon imageRUNNER ADVANCE 6075 Series Service Manual page 451

4
Parts Replacement and Clearning > Image Formation System > Removing the Developing Assembly
CAUTION:Points to Caution when Installing the Developing Assembly
Before installing the Developing Assembly, check that the Buffer Shutter is not open.
If the Developing Assembly is forcibly installed while the Buffer Shutter is open, the
shutter may get damage. When the Buffer Shutter is open, pull out the shutter to the
front and then close it.
Whether the shutter is open or not can be checked with the Shutter Arm.
4 Parts Replacement and Clearning > Image Formation System > Removing the Developing Assembly
• As shown in the figure, hold the Developing Assembly and fit the protrusions at right
F-4-170
Protrusion
F-4-171
and left sides of the Developing Assembly to the rail of the host machine.
rail
4-130
rail
Protrusion
Protrusion
F-4-172
4-130