Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1100

11) Insert the IPSec PCB into the connector on the Expansion PCB to install it.
• 2 Screws (TP; M3x6) (Included in the IPSec Board)
x2
CAUTION:
Install the Main Controller PCB 1 while paying attention not to trap cables.
12) Insert the Main Controller PCB 1 until it stops.
13) Connect the USB Cable and the Control Panel Cable.
14) Insert the terminal of the Antenna for MFP into the terminal of the Main Controller
PCB 1.
9
Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expans
15)
F-9-246
16)
F-9-247
9 Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expans
Install the Side Cover by putting the Antenna for MFP through a hole of the cover.
Close the Right Rear Cover 1.
9-103
HooK
Hole
HooK
F-9-248
9-103