Canon imageRUNNER ADVANCE 6075 Series Service Manual page 933

COPIER > OPTION > NETWORK
IPTBROAD Set to allow broad/multicast TX
Lv.1 Details To set whether to permit transmission of broadcast packets and
multicast packets.
Transmission of broadcast packets and multicast packets is
permitted without specifying an exception address. It is permitted
within the device even if it is rejected in the default setting of the
IPv4/v6 transmission filter.
Set "1: Disabled" when the user does not want to send them.
Use case Upon user's request
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 5
0: Enabled, 1: Disabled, 2 to 5: Not used
Default value 0
PFWFTPRT Set of RST reply at IP filter FTP SEND
Lv.1 Details When FTP SEND is executed using an IP filter by which packets
from a specific remote PC are rejected, SYN is returned to the port
113 if the PC supports authentication of the FTP port 113. However,
since the IP filter blocks the packets, the block logs are increased
and the performance is lowered.
When 1 is set, RST is returned to the port 113 without blocking
packets.
Use case When executing FTP SEND against the OS which supports
authentication of the FTP port 113 while the IP filter is enabled
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
PRNIPBLK ON/OFF of IP address block function
Lv.1 Details To set ON/OFF of IP address block function.
When 1 is set, "IP Address Range Settings" and "RX/Print Range"
screen is displayed on the Control Panel.
Use case When using the IP address block function
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
Related user mode Preferences> Network> TCP/IP Settings> IPv4 Settings/IPv6
Settings> IP Address Range Settings> RX/Print Range
8
Service Mode > COPIER > OPTION > NETWORK
8 Service Mode > COPIER > OPTION > NETWORK
COPIER > OPTION > NETWORK
IPMTU Setting of MTU size
Lv.1 Details To set MTU size of network packet.
This item is used when performing SEND communication between
locations connected with Ethernet in a field environment where MTU
black hole problem occurs.
Use case When MTU black hole problem occur
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 1 to 10
1: 600 byte, 2: 700 byte, ..., 9: 1400 byte, 10: 1500 byte
Unit 100 byte
Default value 10
DDNSINTV Set of DDNS periodical update interval
Lv.1 Details DNS registration is executed only once at start-up with the current
iR, so the registered contents are deleted in an environment where
the DNS server settings are deleted at intervals.
To set the interval of DDNS periodical update for not deleting the
registered contents.
Use case When the DNS server settings are deleted at intervals
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 48
0: No periodical update, 1: 1-hour interval, 2: 2-hour interval, ..., 47:
47-hour interval, 48: 48-hour interval
Unit 1 hour
Default value 24
8-151
T-8-64
8-151