Canon imageRUNNER ADVANCE 6075 Series Service Manual page 993

SORTER > ADJUST
FIN-NIS Tray drive noise reduct mode: Fin-E1
Lv.1 Details Set 1 when the Finisher operation noise is loud.
When 1 is set, the initial Finisher operation is minimized.
The item can be also set with DIP switch of the Finisher (with
common setting range and setting value). The latest setting value is
enabled regardless of service mode/DIP switch.
Use case When the Finisher operation noise is loud
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
1SHT-SHF Set 1-sheet Offset+Collate: Fin-E1
Lv.1 Details Set 1 when setting Offset and Collate for 1-sheet document.
The item can be also set with DIP switch of the Finisher (with
common setting range and setting value). The latest setting value is
enabled regardless of service mode/DIP switch.
Use case When setting Offset and Collate for 1-sheet document
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
SDL-SWCH Sddl stck capacity switch mode:Fin-E1
Lv.1 Details Set 1 when increasing the stacking capacity for saddle stitching.
When 1 is set, the stacking capacity increases over the upper limit.
The item can be also set with DIP switch of the Finisher (with
common setting range and setting value). The latest setting value is
enabled regardless of service mode/DIP switch.
Use case When increasing the stacking capacity for saddle stitching
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
SDL-ALM Saddle full stack alarm mode: Fin-E1
Lv.1 Details Set 1 when disabling the stack full alarm for saddle stitching.
The item can be also set with DIP switch of the Finisher (with
common setting range and setting value). The latest setting value is
enabled regardless of service mode/DIP switch.
Use case When disabling the stack full alarm for saddle stitching
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: ON, 1: OFF
Default value 0
8
Service Mode > SORTER > ADJUST
8 Service Mode > SORTER > ADJUST
SORTER > ADJUST
Z-FL-CH Set Z-fold stapleable quantity:Fin-E1
Lv.1 Details To set the maximum number of stitch pages in Z-fold stapling.
This item is used to prevent missing pages in Z-fold stapling by
decreasing the maximum number of stitch pages.
The item can be also set with DIP switch of the Finisher (with
common setting range and setting value). The latest setting value is
enabled regardless of service mode/DIP switch.
Use case When missing pages occurs in Z-fold stapling
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: 10 sheets, 1: 5 sheets
Default value 0
8-211
T-8-89
8-211