Canon imageRUNNER ADVANCE 6075 Series Service Manual page 454

4
Parts Replacement and Clearning > Image Formation System > Removing the Developing Cylinder and the Developing Roller
2-3) Remove the Developing Assembly Front Cover.
• 3 Screws
x3
CAUTION:
Be sure to hold the Developing Assembly Front Cover to remove the screw.
Otherwise, the Developing Assembly Front Cover may fall, which can cause damage
on the Developing Cylinder.
2-4) Remove the Sleeve Bias Plate.
• 1 Screw
4 Parts Replacement and Clearning > Image Formation System > Removing the Developing Cylinder and the Developing Roller
Points to Caution at Installation:
Since white lines may occur on the image, go through the following steps to match the
phase of the Sleeve Bias Plate and Developing Cylinder Blade.
Fit the Sleeve Bias Plate with the shaft of the Developing Cylinder to install.
F-4-178
F-4-179
4-133
F-4-180
4-133