Setting For Mirroring; Reporting To The System Administrator At The End Of The Work; Execution Of Auto Gradation Adjustment - Canon imageRUNNER ADVANCE 6075 Series Service Manual

Setting for Mirroring

1) Specify the setting for mirroring.
• Service Mode > COPIER > OPTION > FNC-SW > W/RAID; select "1" for W/RAID.
2) Turn OFF/ON the main power switch to enable the setting value.
3) Check that the UI screen is started normally.
4) Open the HDD Cover, and check that the LED is flashing.
• The green LED of HDD1 (Slot1) is flashing.
• The green and red LEDs of HDD2 (Slot2) are flashing.
CAUTION:
Re-building process starts after setting W/RAID to "1".
When the error indicating the message of "Need to replace Hard Disk (Contact with
Service Technician)" on the UI occurs, re-execute the re-building process as follows;
1) Check the lighted Red LED is for the HDD2.
2) Set Service mode > COPIER > OPTION > FNC-SW > W/RAID to "0".
3) Turn OFF/ON the main power switch of the host machine to enable the setting value.
4) Set Service mode > COPIER > OPTION > FNC-SW > W/RAID to "1".
5) Turn OFF/ON e the main power switch of the host machine to enable the setting
value.
The abovementioned procedure is limited only for the re-building process at the initial
installation. The error occurred at re-building process during operation is not targeted.
9
Installation > [TYPE-5] 2 Option HDDs (250GB) + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Execution of Auto Gradation Adjust
Reporting to the System Administrator at the End of the
Work (only when HDD Data Encryption & Mirroring Kit
has been installed)
When you have completed all installation work, report to the system administrator for the
following:
At the point when installation is completed, make explanations about how to check that
the appropriate security function has been added and enabled so that, when the function
becomes uncontrolled, the system administrator can immediately detect the problem and
request <Servicing work when a failure occurs>.
Completion of the Installation Work:
Ask the system administrator to make sure that '2.00' or '2.01' is indicated for 'Canon MFP
Security Chip' as the version information of the security chip by referring to the description
of Checking the Security Version.
Maintenance of the Security Functions:
Ask the system administrator to check the security mark to make sure that the security
functions are maintained each time the machine is started up by referring to the description
of Checking the Security Mark.

Execution of Auto Gradation Adjustment

When this product is installed, the machine initializes its HDD, resetting the data used for
auto gradation adjustment.
Therefore be sure to execute auto gradation adjustment (full adjust) after installing this kit.
F-9-408
9 Installation > [TYPE-5] 2 Option HDDs (250GB) + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Execution of Auto Gradation Adjust
9-191
9-191