4
Parts Replacement and Clearning > Image Formation System > Removing the Developing Assembly
Removing the Developing Assembly
1) Place paper underneath the Developing Assembly.
2) Open the Right Cover.
3) Turn the Tab to open the Plate Cover.
• 1 Screw
4) Remove the Developing Assembly by following the Rail.
• 1 Connector
4
Parts Replacement and Clearning > Image Formation System > Removing the Developing Assembly
CAUTION:How to Hold the Developing Assembly
When holding the Developing Assembly, be sure to hold the handle of the Developing
Assembly as shown in the figure.
Do not touch the shutter area of the Developing Assembly. The shutter area is slippery,
so it may cause a fall of the assembly.
F-4-167
F-4-168
4-129
F-4-169
4-129