4
Parts Replacement and Clearning > Image Formation System > Removing the Post-transfer Static Eliminator
Removing the Transfer Cleaning Unit
<Preparation>
1. Pull out the Fixing Feed Unit. (Refer to "Removing the ETB Unit")
2. Remove the ETB Unit. (Refer to page 4-137)
3. Remove the ETB Drive Unit. (Refer to page 4-153)
<Procedure>
1) Disconnect the connectors.
2) Remove the Transfer Cleaning Unit.
• 1 Stepped Screw
4
Parts Replacement and Clearning > Image Formation System > Removing the Post-transfer Static Eliminator
<Preparation>
1. Pull out the Fixing Feed Unit. (Refer to "Removing the ETB Unit")
<Procedure>
CAUTION:
Do not touch the surface of the ETB when handling the ETB Unit.
1) Remove the Post-transfer Guide Unit.
• 1 Screw
F-4-238
F-4-239
Removing the Post-transfer Static Eliminator
4-156
F-4-240
4-156