Canon imageRUNNER ADVANCE 6075 Series Service Manual page 570

5
Adjustment > When replacing parts > Controller System > Main Controller PCB 2
2. When Replacing
1) Transferring the parts from old PCB to new PCB
• DDR2-SDRAM (1 pc.) (When option DDR2-SDRAM is installed: 2 pc.)
• Memory PCB
DDR2-SDRAM
Prohibited Operation:
Do not transfer the following parts to another model (which has a different serial
number).If you fail to do so, the Main Body does not activate normally and this might
cause to fail the restoration.
• Main Controller PCB 1
• Main Controller PCB 2 (with Memory PCB installed)
• Memory PCB
5 Adjustment > When replacing parts > Controller System > Main Controller PCB 2
Memory PCB
F-5-4
3. After Replacing
1) After installing the parts, turn ON the main power switch.
2) Restoring the backup data
Use the Remote UI.
Management Settings > Data Management > Import/Export
3) Resetting/registering the data
While referring to the list of set/registered data which was printed out before
replacement, reset/register the data.
4) When the user generates and adds the encryption key, certificate and/or CA certificate,
request the user to generate them again
5-6
5-6