Cst-Adj - Canon imageRUNNER ADVANCE 6075 Series Service Manual

COPIER > ADJUST > FEED-ADJ
LP-DUP2 Duplex pre-rgst arch amount:Hvy/Transp
Lv.1 Details To adjust the arch amount before registration when feeding heavy
paper/transparency in duplex mode.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
REG-SPD Speed adj Registration Motor:1/1 speed
Lv.1 Details To adjust 1/1 speed of the Registration Motor.
+: The speed is increased.
-: The speed is decreased.
Use case - At occurrence of an image failure
- When the leading edge margin becomes larger due to wear of the
Registration Roller
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -10 to 10
Default value 0
TBLT-SPD Fine adjustment of ETB speed
Lv.1 Details To make a fine adjustment of the ETB speed.
+: The speed is increased.
-: The speed is decreased.
When the speed is changed, image magnification in the vertical
scanning direction is changed.
Use case When image magnification is changed due to replacement of ETB,
etc.
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -200 to 200
Unit 0.1 mm/sec
Default value 0
8
Service Mode > COPIER > ADJUST > CST-ADJ
T-8-36
8 Service Mode > COPIER > ADJUST > CST-ADJ

■ CST-ADJ

COPIER > ADJUST > CST-ADJ
MF-A4R Adj of MP Tray A4R paper width
Lv.1 Details To adjust the width of A4R paper in the Multi-purpose Tray.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
When replacing the Multi-purpose Tray Paper Width Detection PCB
or registering a new value, execute COPIER> FUNCTION> CST>
A4R.
Use case - When replacing the DC Controller PCB/clearing RAM data
- When replacing the Multi-purpose Tray Paper Width Detection PCB
or registering a new value
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range 0 to 255
Related service mode COPIER> FUNCTION> CST> A4R
MF-A6R Adj of MP Tray A6R paper width
Lv.1 Details To adjust the width of A6R paper in the Multi-purpose Tray.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
When replacing the Multi-purpose Tray Paper Width Detection PCB
or registering a new value, execute COPIER> FUNCTION> CST>
A6R.
Use case - When replacing the DC Controller PCB/clearing RAM data
- When replacing the Multi-purpose Tray Paper Width Detection PCB
or registering a new value
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range 0 to 255
Related service mode COPIER> FUNCTION> CST> A6R
8-93
8-93