Feed Faults; Paper Wrinkle; Other; Adjusting Rotation Of The Upright Control Panel Arm - Canon imageRUNNER ADVANCE 6075 Series Service Manual

Feed Faults

Paper wrinkle

<Location>
Fixing Roller, Pressure Roller
<Cause>
Right after the startup, temperature is different between the center and the edge of the
Fixing Roller (temperature: center > edge).
Because a slippery solid black image does not match to the nip shape when it is fed, the
center of paper is pulled toward the feeding direction, causing paper wrinkle.
<Condition>
Timing: Approx. 20 sheets immediately after the startup first time for the day
Paper size: Paper size larger than B4
<Field Remedy>
If 2 is set, control temperature is increased by performing idle rotation when printing to
A3/LDR or larger size paper at the start of printing in a normal humidity/high humidity
environment. Paper wrinkle which occurs at this time can be decreased, but first copy time
becomes longer. In other cases, idle rotation is not performed.
If paper wrinkle occurs on paper larger than B4, increase the setting value from 2 in
increments of 1 until paper wrinkle is alleviated.
If paper wrinkle occurs on B4 size paper, increase the setting value from 4 in increments of
1 until paper wrinkle is alleviated.
COPIER>OPTION>BODY>FX-WNKL
[Setting values]
0: OFF
1: OFF (Default)
2: When paper is A3/LDR or larger size paper in a normal humidity/high humidity
environment, idle rotation is performed for up to 10 seconds.
3: When paper is A3/LDR or larger size paper in a normal humidity/high humidity
environment, idle rotation is performed for up to 20 seconds.
4: When paper is B4 or larger size paper in all environments, idle rotation is
performed for up to 10 seconds.
5: When paper is B4 or larger size paper in all environments, idle rotation is
performed for up to 20 seconds.
6: When paper is B4 or larger size paper in all environments, idle rotation is
performed for up to 30 seconds.
6
Troubleshooting > Other > Adjusting rotation of the Upright Control Panel Arm
6 Troubleshooting > Other > Adjusting rotation of the Upright Control Panel Arm

Other

Adjusting rotation of the Upright Control Panel Arm

If rotation of the Upright Control Panel Arm has become loose, retighten the Fixation Screws
securing the Arm Rotation Adjustment Ring according to the following procedure.
<Procedure>
1) Remove the Shaft Support Cover (Left) and the Shaft Support Cover (Right).
2) Open the DADF and retighten the 2 Fixation Screws securing the Arm Rotation Adjustment
Ring.
NOTE:
If rotation of the arm is still loose after retightening the Fixation Screws according to
"●Adjusting rotation of the Upright Control Panel Arm", change the phase difference
between the Arm Rotation Adjustment Ring and the Fixation Screws according to the
following procedure.
6-24
F-6-42
6-24