Procedure For Backing Up The Meap Application Area Using Sst - Canon imageRUNNER ADVANCE 6075 Series Service Manual

2
Technology > MEAP > Backup of the MEAP Application Area and Recovery of the Backup Data Using SST > Procedure for backing up the MEAP application area using SST

■ Procedure for backing up the MEAP application area using SST

1) Switching Login Service / Backup of Login User Information
If SSO-H is used for the login service, switch to default authentication before backing
up the user information. Although SST will back up local device user information, it is
recommended to export the user information just in case. For local device user information
backup, go to User Management page of SSO-H site and export the data. (The SSO-H
login page opens with the URL "https://<device IP address>:8443/sso/").
CAUTION:
• If a hard disk of a system that uses SSO-H is formatted without changing the login
service to the default authentication, the error message "The login service must be
set again with SMS" appears and the system cannot start up when you attempt to
restart the system after formatting.
• If this problem occurs, change the login service to SSO-H with SMS. If you cannot
access to SMS since you do not have the IP address of the device, start the system
with FIXIP mode -hold down the numeric keys 1 and 7 and turn the power switch on.
The IP address "172.16.1.100" will be automatically assigned for the device. Then
log in to SMS specifying the address.
2) Starting the device in Download Mode
Press [2] and [8] buttons at the same time on the control panel and turn on the main power
switch to start the device in Download Mode. Note that SST backup function is enabled
only in Download Mode.
3) Connecting the main unit to the PC to start SST
Connect the main unit to the PC with SST installed using the crossing cable and the like to
start SST on the PC.
2 Technology > MEAP > Backup of the MEAP Application Area and Recovery of the Backup Data Using SST > Procedure for backing up the MEAP application area using SST
4) Connecting the device using SST
When starting SST, select the target device type as Single and click [Start] button.
5) Generating backup data to transfer it to the PC (uploading)
Click [Upload Data] button of SST and select "Meapback.bin" as the item to be backed up
to click [ Start ] button.
2-202
F-2-282
F-2-283
2-202