Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1135

2) Install the Conversion Connector.
CAUTION:
Be sure that there is no gap between the HDD Connector and the Conversion
Connector.
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Assembling the Option HDD
3) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
• 2 Screws (P Tightening; M3x8)
CAUTION:
• Be sure to firmly hold the Connector Fixation Block when tightening the screws.
• Be sure to follow the correct order to tighten the screws, otherwise the Conversion
F-9-307
9 Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Assembling the Option HDD
Connector may not be connected properly, resulting in poor contact.
x2
9-138
F-9-308
Boss
Hole
F-9-309
9-138