Removing The Drum Cleaning Unit - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Unit

Removing the Drum Cleaning Unit

<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Primary Charging Assembly. (Refer to page 4-97)
3. Remove the Pre-transfer Charging Assembly. (Refer to page 4-108)
4. Remove the Process Unit. (Refer to page 4-114)
<Procedure>
CAUTION:
Do not touch the surface of the Photosensitive Drum.
After removing the Drum Cleaning Unit, place paper over the Photosensitive Drum to
block light.
1) Remove the Drum Cleaning Unit.
• Edge Saddle
• 1 Connector
• 4 Screws
x4
4 Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Unit
CAUTION:
When installing the Drum Cleaning Unit, clean the area shown with lint-free paper
moistened with alcohol.
If the Drum Cleaning Unit is installed without removing toner, it cannot be installed in
the correct position, causing the cleaning error.
F-4-140
4-117
F-4-141
4-117