Replacing The Primary Charging Wire - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Wire
CAUTION:
Be sure to move the Primary Charging Wire Cleaners (Left and Right) until they stop
and tighten the screws.
Screws
Primary Charging
Primary Charging
Wire Cleaners (Left )
Wire Cleaners (Right)
16) Install the Primary Charging Shutter Unit.(Refer to page 4-147)
4 Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Wire

Replacing the Primary Charging Wire

NOTE:
Replacement procedure is the same between the Primary Charging Wire (Left) and the
Primary Charging Wire (Right).
The following explains the procedure of the Primary Charging Wire (Right).
NOTE:
The Primary Charging Wire with spring is set as a service part.
CAUTION:
In the case of replacing the Charging Wire on a Charging Wire basis, be sure to use
the dedicated Charging Wire Tension Spring (97-5527) [A]. Do not use the Spring [B]
attached to the Charging Wire.
F-4-107
<Preparation>
1. Open the Front Cover.
2. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
3. Remove the Primary Charging Assembly. (Refer to page 4-97)
4. Remove the Primary Charging Wire Cleaner Holder (Right). (Refer to "Removing the
Primary Charging Wire Cleaner, Cleaner Holder (Right/Left)")
5. Remove the Primary Charging Wire Cleaner (Right). (Refer to page 4-98)
Spring [B] Spring [A]
F-4-108
4-104
4-104