Displaying Logs; Update Logs - Canon imageRUNNER ADVANCE 6075 Series Service Manual

2
Technology > System Management Operations > Displaying Logs > Update Logs
5. Select a log level from [Log Level] dropdown list.
• [Log Level]:
Select one of 5 levels ranging from [0] to [4].
See the table below for logs output in each level.
Log Level
Trace Information Important Message
0 - -
1 - -
2 - -
3 - Yes
4 Yes Yes
NOTE:
This list shows the contents of the Log Output.
Log Output
Trace Detailed logs for debug
Information Logs related to operations done on the system
Important Message Update logs output by firmware type
Installation logs by MEAP application
Logs related to enabled functions by system option
Ordinary Error Logs for ordinary errors
System Error Logs for internal system errors
6. Press [OK] button to set the selected log level. Now the log level is successfully set.
2 Technology > System Management Operations > Displaying Logs > Update Logs
F-2-379
Log Output
Ordinary Error System Error
- - Yes
- Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Description
T-2-130

Displaying Logs

■ Update Logs

This section describes how to confirm System Option/MEAP Application Installation Logs and
Firmware Update Logs.
1. Start [Service Mode] at Level 1.
1). Press [Setting/Registration (User Mode)] button on the control panel.
2). Press [2] and [8] buttons at a time on the control panel.
3). Press [Setting/Registration (User Mode)] button on the control panel.
4). [Service Mode] screen is shown.
2. Press [Updater] button.
3. Press [Software Management Settings] button.
T-2-129
2-254
F-2-380
2-254