Canon imageRUNNER ADVANCE 6075 Series Service Manual page 426

4
Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Wire
<Procedure>
<Removing the Charging Wire>
1) Remove the Sheet.
2) Use tweezers to hold the tip of the Spring at the rear side to remove the Spring from the
charging electrode and remove the Charging Wire from the groove of the Positioning Block.
4 Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Wire
F-4-109
Groove
Charging
Electrode
F-4-110
3) Remove the Charging Wire from the protrusion and the groove of the Positioning Block at
the front side.
Protrusion
<Installing the Charging Wire>
NOTE:
When installing the Charging Wire set as a service part, steps 4, 5, 7, and 8 are not
required.
4) Untie approx. 5cm of the Charging Wire from the 0.06mm (wire-diameter) Charging Wire
Reel to make a 2mm-diameter ring at the edge.
NOTE:
The ring can be easily made by the following procedure: Wrap the Charging Wire
around the Hex Key to make a full round, and then turn it for 3 to 4 times to twist the
Charging Wire.
4-105
Groove
Charging
Wire
F-4-111
4-105