Canon imageRUNNER ADVANCE 6075 Series Service Manual page 279

2
Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
2. Select [COPIER] > [Function] > [CLEAR] > [ERDS-DAT] and touch the [OK] button.
This operation initializes the E-RDS settings to factory setting values.
For the setting values to be initialized, see the section of "Initializing E-RDS settings".
3. Perform installation or deletion of the CA certificate if necessary, and reboot the device.
• Installation of the CA certificate: Perform installation from SST.
• Deletion of the CA certificate: When the following operation is performed, the CA certificate
in the factory setting is automatically installed.
(1) Start [Service Mode] at Level 2.
1) Press [Settings/Registration (User Mode)] button on the control panel.
2) Press [2] and [8] buttons at a time on the control panel.
3) Press [Settings/Registration (User Mode)] button on the control panel.
4) Touch the [Mode List] button on the [Service Mode] screen.
5) Press [Settings/Registration (User Mode)] button on the control panel.
6) Press [2] button on the control panel.
2 Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
(2) Select [COPIER] > [Function] > [CLEAR] > [CA-KEY] and touch the [OK] button.
(3) Reboot the device.
F-2-323
4. Activate [SERVICE MODE] in LEVEL 1. (See 1. for the procedure.)
5. Select [COPIER] > [Function] > [INSTALL] > [E-RDS].
2-225
F-2-324
F-2-325
2-225