4
Parts Replacement and Clearning > Fixing > Cleaning the Inner Delivery Roller
4) Turn over the Fixing Inlet Guide Unit, and insert lint-free paper into the clearance (front
side) between the Fixing Inlet Sensor Flag Shaft and the Shaft Support Plate to remove the
accumulated paper lint by dry wipe.
5) Slide the sensor flag to the rear side, and insert lint-free paper into the clearance (rear
side) between the Fixing Inlet Sensor Flag Shaft and the Shaft Support Plate to remove the
accumulated paper lint by dry wipe.
CAUTION:Checking after Cleaning the Fixing Inlet Sensor Flag Shaft
Be sure to check that the sensor flag rotates and moves back and forth smoothly by
moving it manually.
4
Parts Replacement and Clearning > Fixing > Cleaning the Inner Delivery Roller
Cleaning the Inner Delivery Roller
<Preparation>
1. Pull out the Fixing Feed Unit. (Refer to "Removing the Fixing Assembly")
2. Remove the Fixing Assembly. (Refer to page 4-176)
<Procedure>
1) Clean the Inner Delivery Roller with lint-free paper moistened with alcohol.
F-4-315
F-4-316
4-179
F-4-317
4-179