Canon imageRUNNER ADVANCE 6075 Series Service Manual page 423

4
Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Assembly Grid Wire
6) Untie approx. 5cm of the Charging Wire from the 0.1mm (wire-diameter) Charging Wire
Reel to make a 2mm-diameter ring at the edge.
NOTE:
The ring can be easily made by the following procedure: Wrap the Charging Wire
around the Hex Key to make a full round, and then turn the Hex Key for 3 to 4 times to
twist the Charging Wire.
7) Cut the twisted Charging Wire (extra length) with nippers.
8) Hook the ring to the Stud A as shown in the figure.
4 Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Assembly Grid Wire
9) After setting the wire 35 times around, pass through B part. After turning over the Primary
Charging Assembly, pass the wire between the washer and the Motor Unit, wrap around
the screw clockwise to make a full round and secure with the screw.
Stud A
4-102
B part
Screw
turning over
B part
F-4-102
4-102