12) Install the supplied AC input connector in 2 steps ([A] > [B]).
Secure the ground cable.
• 1 screw with toothed washer
[B]
9
Installation > Paper Deck Heater Unit-A1 > Installation Procedure (Paper Deck Unit-A1)
[A]
x1
F-9-136
9
Installation > Paper Deck Heater Unit-A1 > Installation Procedure (Paper Deck Unit-A1)
13) Install the relay hareness unit to the rear side panel of the paper deck.
• 2 screws (RS-tight; M4x8)
x2
x2
14) Insert the bind locks of the cable ties in the holes (at [A] shown below) in the rear side
panel to secure the relay harness.
15) Connect the connector at both ends of the relay harness unit to the heater connector and
AC power connector respectively.
16) Reatach the exterior covers of the paper deck in the following sequence;
[1] Top cover (take care not to have the cables caught)
• 2 screws (RS-tight; M4x8)
[2] Front-upper cover (insert the connector)
• 3 screws (RS-tight; M4x8)
[3] Rear cover
• 4 screws (RS-tight; M4x8)
• 2 screws (Binding; M3x8)
[4] Right cover
• 3 screws (RS-tight; M4x8)
9-62
[A]
F-9-137
9-62