Parts to be used differs depending on models; thus, refer to the following tabls.
No
Name
Q'ty
[1]
Card Reader Mounting Plate
1pc
[2]
Card Reader
1pc
[3]
Connector Cover1
1pc
[4]
Connector Cover2
1pc
[5]
Card Reader External Relay
1pc
Harness
[6]
Connector Case
2pcs
[7]
Cord Guide
1pc
[8]
PCB Spacer
1pc
[9]
Screw (TP; M4x12)
1pc
[10]
Screw (RS tight; M4x8)
1pc
[11]
Screw (Bindeing; M4x20)
1pc
[12]
Screw (TP; M3x6)
1pc
Check Items when Turning OFF the Main Power
Check that the main power switch is OFF.
1)
Turn OFF the main power switch of the host machine.
2)
Be sure that Control Panel Display and Main Power Lamp are both turned OFF, and
then disconnect the power plug.
9
Installation > Card Reader-C1/Copy Card Reader-F1 > Installation Procedure
Upright Control Panel Flat Control Panel
Yes
No
Yes
Yes
Yes
Yes
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
No
No
Yes
Yes
Yes
T-9-6
9
Installation > Card Reader-C1/Copy Card Reader-F1 > Installation Procedure
Installation Procedure
CAUTION:
• Refer to "Combination of options" when installing this equipment before operation.
• After installing the Card Reader, enter the card number to be used in the following
service mode of this equipment: COPIER > FUNCTION > INSTALL > CARD.
Otherwise, the card will not be recognized even inserting it.
NOTE:
Although model with the Upright Control Panel is used for illustration in this procedure,
the same procedure is applied to model with the Flat Control Panel.
1)
Press [A] part, and open the Right Rear Cover 1.
[A]
9-80
F-9-187
9-80