Check Items when Turning OFF the Main Power
Check that the main power switch is OFF.
1)
Turn OFF the main power switch of the host machine.
2)
Be sure that Control Panel Display and Main Power Lamp are both turned OFF, and
then disconnect the power plug.
Installation Procedure
CAUTION:
Refer to "Combination of options" when installing this equipment before operation.
NOTE:
Although model with the Upright Control Panel is used for illustration in this procedure,
the same procedure is applied to model with the Flat Control Panel.
1)
Press [A] part, and open the Right Rear Cover 1.
[A]
9
Installation > Voice Guidance Kit-F1/F2 > Installation Procedure
2)
Remove the Side Cover.
• 1 Screw (The removed screw will be used in step 11.)
• 2 Hooks
3)
Disconnect the USB Cable and the Control Panel Cable.
4)
Hold the handle and remove the Main Controller PCB 1 while holding the cables.
F-9-210
9
Installation > Voice Guidance Kit-F1/F2 > Installation Procedure
Hook
Hook
x2
Control Panel Cable
USB Cable
Main Controller PCB 1
Handle
9-89
F-9-211
F-9-212
9-89