Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1122

4) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
• 2 Screws (P Tightening; M3x8)
CAUTION:
• Be sure to firmly hold the Connector Fixation Block when tightening the screws.
• Be sure to follow the correct order to tighten the screws, otherwise the Conversion
Connector may not be connected properly, resulting in poor contact.
x2
9
Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Disassembling and Assembling of the HDD Removed from the Host Machin
F-9-283
Boss
Hole
F-9-284
9 Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Disassembling and Assembling of the HDD Removed from the Host Machin
5) Install the HDD Cover.
• 1 Claw
• 1 Screw (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP screw.
Claw
6) Install the HDD Handle.
• 2 Screws (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP screw.
x2
9-125
F-9-285
F-9-286
9-125